FUEL INJECTOR – Remove & Replace – V6,3.5L Eng All
SFM INDUCTION SYSTEM CLEANING
Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
WINDOW REGULATOR – Remove & Replace – Front,RIGHT SIDE
AXLE SHAFT ASSEMBLY -Remove & Replace – One Side PASSENGER – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
PCV VALVE – Remove & Replace
STEERING KNUCKLE – Remove & Replace – One Side – [DOES NOT include alignment.]
OIL PAN GASKET – Remove & Replace – 3.8L Eng Upper & Lower,Assembly
JEREME D. gave our service a 5 star review on 2/18/2025
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
AUTOMATIC TRANSMISSION FLUID – Drain & Refill – [Includes: Additional time for use of scan tool to perform this procedure.]
SPARK PLUGS – Remove & Replace
DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
PCV VALVE – Remove & Replace
Oscar B. gave our service a 5 star review on 12/16/2024